Don t waste money make your own diy gutter guard.
Making your own gutter guards.
You may need to buy a new section if a scrap piece is not available.
Making your gutter guard.
The best way to make a gutter splashguard is to use a scrap piece of downspout.
The design we use here can be completed in just 3 steps and with affordable materials.
Add 2 inches to the length and width measurements to obtain the final measurement result.
You will need wire mesh which is sold in 100 foot aluminum rolls that are 8 inches wide.
Measure the length and width of each gutter section with a measuring tape and mark the measurements on a notepad.
Using the hacksaw cut the roll s of mesh in half making 2 rolls 4 inches wide.
They can be cut into 4 inch wide rolls using the hacksaw.
How to make your own gutter guards step 1.
Cut wire mesh sections using a.
Follow the steps below if you want to make your own gutter guards.
Spray paint the mesh to provide enhanced rust oxidation protection.