A demonstration start to finish of how to make cabinet doors primarily on a table saw.
Making shaker doors with a table saw.
You can build new cabine.
Make sure you have the kreg jig to the right setting.
I made two on the short ends and three on the long sides.
Apply glue to the top tenons and the ends of the grooves in the other stile and tap the stile into place.
Get help with the hinges.
Do you have old cabinets that you d like to replace.
And if you are starting with wood that is already surfaced and squared then you can build the entire door with just a table saw and miter saw.
Next run a bead of wood glue on the tongue of the remaining rail and slide it into place.
Lay the door assembly on the planed 2 x 4 s and clamp.
A basic woodworking shop is all you need to build strong beautiful c.
Hold this in place while slipping the 1 4 inch plywood into the grooves.
Clamp the shaker door with bar clamps and leave for at least three hours.
Wait at least an hour before removing the clamps.
Wipe up the excess glue with a putty knife and a damp rag.
Other than the hinges there is no metal just wood and glue.
If the boxes are in good shape you may just need to replace the cabinet doors.
Building shaker cabinet doors is only part of the story.
Run a bead of the wood glue on the tongues of one rail and slip it into the grooves in the stiles.
If the door is touching the 2 x 4 s at each corner you ll know the door is flat.
From each end using the table saw.
To even up the ends of the door cut 1 16 in.
Once you have your panel cut make kreg jig pilot holes following ana s directions.
Shaker style doors add a simple and clean look to your cabinets and add a level of true craftsmanship to your cabinet project.